Has anyone had problems getting the vent to repressurize after a disconnect. We are finding it necessary to turn the bias flow up to reach enough pressure before the vent will pressurize
quote:Originally posted by rdrrt@charter.net: Has anyone had problems getting the vent to repressurize after a disconnect. We are finding it necessary to turn the bias flow up to reach enough pressure before the vent will pressurize
I've never worked with the B, but on the A, if the MAP drops below a certain %, you must press and hold the reset button till the MAP rebuilds.
IS THIS when you press the Re-set button? This is required if the Pressure drops too low, or too high, and this is a safety measure because You know what happens to lungs at high pressures, and disconnects are of corse requiring Re-Pressurizing because without MAP the motor would burn up.
